Anonymous
Not applicable
Jun 21, 2012
04:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 21, 2012
04:30 AM
Can i use CYFI Low power RF module (CYRF7936) with CY8CKIT-001 development kit to implement wireless sensor network.......
Labels
- Labels:
-
PSoC 3
4 Replies
Anonymous
Not applicable
Jun 24, 2012
09:29 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 24, 2012
09:29 AM
plz any one of U give reply for my question.....plz....
Jun 24, 2012
01:12 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 24, 2012
01:12 PM
Isn't there a connector just for the use of CyFi boards on the Kit-001-board? I did not yet plug one into, but it should work.
Bob
no need to complain, I had some days off 😉
Anonymous
Not applicable
Jun 27, 2012
07:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 27, 2012
07:41 PM
Yes,
you most certainly can.
Infact,there is already some sample code for it with PSoC1,and I am cleaning up my code for the PSoC3/5 too.I will attack that properly once I finish my current project.
Anonymous
Not applicable
Jun 27, 2012
07:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 27, 2012
07:47 PM
You could write out the interfacing code yourself,and then the wireless stack.Its not that complicated to get it up and running.
Check this out for reference http://www.cypress.com/?rID=14467