- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I have large amount of data to be transferred from FPGA to FX3 and then to PC (one direction). At present, our FPGA system is still in design. I plan to connect the related GPIF pins to GND or VCC to test the SlaveFifoAsync example. Then how could I check the throughput of the data transfer in this case (I did it in the USBBulkSourceSink example with Streamer)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried with the same streamer application.
You can use the same application for measuring the throughput in this scenario as well.
Please make sure that VID and PID of SlaveFifoAsync example code is listed in the cyusb3.inf.
Regards,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, RSKV,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK. I have gone through the Streamer application soruce code.
Basically it is looking for the devices with PID F1.
So, please change the PID value of SlaveFifoAsync example to F1. (You can go to cyfxslfifousbdscr.c file and change the PID value to F1).
Then streamer application will identify your device without any issues.
Please let me know if not.
Regards,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much. It works now.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good to hear that. 🙂