Anonymous
Not applicable
Jul 05, 2012
05:41 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 05, 2012
05:41 AM
Hi all,
How can I check the transfer error status in BULK transfer?
Is there any error status register?
and, if 3 times retry fails, What happens?
also Can the firmware know this situation?
Regards,
HC
2 Replies
Anonymous
Not applicable
Jul 05, 2012
09:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 05, 2012
09:04 AM
i would like to get few more details to help you. So could you please add few more details like:
What is the application that you are trying and what is the behaviour that you are observing.
Regards,
sai krishna.
Anonymous
Not applicable
Jul 06, 2012
10:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 06, 2012
10:45 PM
Hi sai krishna,
During massive bulk transfer of image data, BeginDataXfer, WaitForXfer, FinishDataXfer functions return error and
this error does not recorvered.
cable and USB card change alter this situation, especially bad cable makes much error.
so I think communication error occurs, I would like to check error exists or not.
Regards,
HC