- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
can anyone tell how to view analog analyser window in a creator project?
thnx in advance..
- Labels:
-
PSoC 3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi hli!
it shows error in renaming .exe file.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
logic analyser are used in digital circuit to compare logic high and low values.
anybody tell whats the use and what is analog logic analyser?
is analog logic analyser is equivalent to digital storage oscillioscope(DSO/CRO)?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The analog analyzer is a part of the Creator 2.0 software and shows the routing of the analog resources performed for your chip-desing. Since some of the routes are including resistors you can get the information to alter the way the fitter assigns resources and routes.
Sadly this is not a logic analyzer
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Actually, it is called "analog design viewer", and this name makes clear what it is.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@neha: you should not rename the exe file. You need to modify the shortcut calling the creator .exe (maybe you need to copy it beforehand to your shorthand), adding the parameter /adv (IIRC ).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thnx All!
wish thr ws a logic analyser as well...
Regards,
Neha
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Here is an open source design using PSOC 5 -
http://beaversource.oregonstate.edu/projects/44x201107/wiki/WikiStart
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
... and hli built one based on PSoC5 too! Have a look at this thread http://www.cypress.com/?app=forum&id=2232&rID=65870
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Analyzers also typically these days are accompanied by stimulus generators.
PSOC DMA = Pattern generator, ability to program digital I/O logic levels, timer/counter implementation of N
burst of N pulses generator, duty cycle, all easily achived by PSOC 3/5. Even the ability to verify PHY
characterisitcs of a digital interface.
A significant part of this can be implemented in Verilog to optimize speed. and simplicity of design.
Regards, Dana.