Anonymous
Not applicable
Jul 25, 2012
01:38 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2012
01:38 AM
Hello,
How to get flag of "CYU3P_GPIF_OP_THR0_READY" in code?
Regards,
lian
1 Reply
Anonymous
Not applicable
Jul 25, 2012
02:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 25, 2012
02:15 AM
Basically "CYU3P_GPIF_OP_THR0_READY" is one of the control output or status flag from the GPIF hardware to the external processor that is connected to FX3.
For using this, you need to have a control line on the GPIF interface (which you can do using GPIF II designer) and then you need to use the "CyU3PGpifOutputConfigure" API to configure that control output line.
Regards,
sai krishna.