2 Replies Latest reply on Aug 27, 2012 4:07 AM by userc_43940

Error:CPU is not halted

userc_43940 Aug 18, 2017 2:27 PM

Hi everyone:

When I setup the debug mode with JTAG GDB,through the J-Link command Tool the ARAM9 is recognized,but the J-Link show a error message :"Error:CPU is not halted".And I follow the chapter 12 of FX3 programmers manual（DOC.#001-64707）to setup the eclipse IDE Debugger，then the tool show a error message “An internal error occurred during: "Label Job".

java.lang.NullPointerException

”.as attached file.

could you please give some advice to slove the problem.

Thanks for your attention and help！

error2.png 162.0 K

1. Re: Error:CPU is not halted

RoKl_290166 Aug 27, 2012 2:09 AM (in response to userc_43940)

Hi,

did you specify the executable file in the debug-configurations?

Go to <Run> -> <Debug Confurations...>, select the configuration you want to use for debugging, select the "Main"-tab in the right part of the window and set at "C/C++ Application:" the according elf-file to be debugged!



Regards!
Like Show 0 Likes(0)

Actions
2. Re: Error:CPU is not halted

userc_43940 Aug 27, 2012 4:07 AM (in response to userc_43940)

Hi Robk:

It's seems OK now! Thank you for suggestion!

Best wishes!
Like Show 0 Likes(0)

Actions

Go to original post