- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
where is have the reference designe ?
Thanks.
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As of now, we do no have any reference designs using PSoC3 + CYRf6936. I will inform you if i can figure out some example project for you.
Regards,
Sai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello, The cypress have some designe about the psoc3 + cyrf7936 ?
thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nope..Right Now we do not have any designs with CYRF7936 + PSoC3
Regards,
Sai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there any progress on supporting CYFI on PSoC3 devices ?
I found in manual CY8CKIT-003 PSoC 3 FirstTouch Starter Kit Guide - where on page 12 is written:
Wireless modules such as ArtaFlex Radio Modules or Cypress Low-power Radio modules such as CYWM6934/35 (not provided with the kit) can be plugged into the Wireless expansion connector on the board. You can design your own radio module using the Cypress CyFI low-power chip CYRF7936-40LXI.
I don't see still any CYFI user modules like in PSoC1 ...
Best Regards
Radim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This thread should be of help to you - http://www.psocdeveloper.com/forums/viewtopic.php?f=42&t=6680
P.S. (wondering why this thread has jumped into the PSoC 1 section all of a sudden)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Arvi,
yes of course I know that there are few projects using CYRF chip with PSoC3 but it is only for point to point communication. But I would like to need full CYFI STACK (protocol). I am now using PSoC1 with USB but there is very small only 16kB flash memory (cyfi and USB user modules consumes about 11kB flash and I have no room for specific code...). Will be here native PSoC3 support in near future?
Regards
Radim