Anonymous
Not applicable
Sep 04, 2012
11:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 04, 2012
11:27 PM
Hello All
Does the transfer rate increase when the Burst count is higher......the reason why I ask this question is , in the emfile component I found that that if i buffer lot of bytes and then transfer huge data the transfer rate increases.......
The rate increase may also due to additional header or foooter formats required when each data byte is transferred..... I am not sure....
Labels
- Labels:
-
PSoC 5LP
1 Reply
Sep 05, 2012
08:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 05, 2012
08:51 AM
Yes, because then you spare the setup / preparation times. The TRM has a nice formula to calculate how long a transfer takes.