- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, everyone,
Is there any evaluation board with both USB3.0 and FPGA? Now I have the FX3 CYUSB3KIT-001 development kit. I am afraid it is damage by the overshooting of the PCLK (80MHz, distorted peaks). So I want to get an evaluation board integrated with FPGA. Is it available?
Thank you very much
Lehua Chen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please go through the below link:
http://www.enclustra.com/en/products/fpga-manager-en/fpga-manager-fx3/
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Opal Kelly has the XEM6310 coming soon. Their products are an integrated solution with the FX3 firmware complete and part of the unit. http://www.opalkelly.com/
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We have also developed a board with full software stack, which uses FX3:
You can find more information at : http://www.linera.com.tr/en/products-and-services/products/
FMU3-S6 series is a spartan-6 based board with USB3.0 support. It has an on-board DDR3, a programmable clock synthesizer, Flash, and a microSD card slot, all in a 65x50mm package.
FM-S6 series does not have an FX3 on-board, but it is smaller: (50x50mm) and is pin-compatible with FMU3-S6!