Anonymous
Not applicable
Oct 16, 2012
12:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 16, 2012
12:48 AM
Hello,
In our system, FX3 and FPGA are connected by Synchronous Slave FIFO interface(32bit bus).
We have a question about the sequence for performing reads from it.
If a master(FPGA) starts asserting of SLCS and SLRD simultaneously, is it a problem for a slave(FX3)?
In Figure3 of the Application Note(AN65974_001-65974.pdf), it begins to assert SLRD after 1 cycle of PCLK from SLCS.
And, the description about the timing is not found besides the figure.
Do we have to design according to the timing of this figure?
Regards,
kommy2
2 Replies
Anonymous
Not applicable
Oct 16, 2012
02:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 16, 2012
02:08 AM
Hi Kommy,
FX3's slaveFIFO interface should work normally even if you assert SLCS, SLRD, SLOE simultaneously.
Thanks,
sai krishna.
Anonymous
Not applicable
Oct 24, 2012
12:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 24, 2012
12:45 AM
Hi sai krishna,
Thank you for your reply.
We understand your answer about our question.
Regards,
kommy2