Anonymous
Not applicable
Oct 23, 2012
02:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2012
02:51 PM
Hi
I use a timer and I want to change the clock source from VC2 to VC3 during program execution. Is it possible to change the clock source in the program? If so, how? Thank you for your response
Labels
- Labels:
-
PSoC 1
3 Replies
Oct 23, 2012
03:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 23, 2012
03:47 PM
Take a look at the Technical Reference Manual, TRM, there is a register,
DxBxxIN, for each digital block that controls clock source. Also pay close
attention to special notes, sometimes it takes more than a simple write to
effect the changes.
Regards, Dana.
Anonymous
Not applicable
Oct 25, 2012
07:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2012
07:44 AM
Hello,
thank you for your reply, but I can not find the Technical Reference Manual for CY8C29466. Where can i get this ?
Regards Łukasz
Oct 25, 2012
08:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 25, 2012
08:12 AM
In PSOC Designer, "Help", "Documentation", "Technical Reference Manuals".
Regards, Dana.