- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
I have a simple question. Is it possible with a PSoC 5 First Touch into sleep mode to come? My PSoC 5 will not go into the ILO 1 kHz clock mode.In sleep mode, my board has a current of I = 40mA. What's the problem?
Can you help me with this problem?
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This covers mods in several boards to perform sleep measurements -
www.cypress.com/?docID=37054
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you have the CY8CKIT-014, follow the guiding principles in the prior commented
application note. Eg. examine your schematic for loads that may alter your sleep
measurements.
Regards, Dana.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the fast answer.
I'll try to bring the board CY8CKIT-014 with the instructions into sleep mode.
Regards, Sven.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
kHz crystal pins (P15[2] & P15[3]) are used for accelerometer in the First touch kit. So you can not use RTC in that kit. But any low power projects with Sleep timer can be done on FTK. May be the power consumption will be litter higher than what you can observe in the -030 or -050 kits.