Anonymous
Not applicable
Dec 04, 2012
03:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 04, 2012
03:31 AM
Hi, on my project, PSoc wakes up when any interrupt occurs on UART1 and normally it works fine. But sometimes the reset happens during wake up and the system runs as initial. Here is the snippet of my codes. I2C_Sleep(); Timer_1_Sleep(); UART_Upper_Sleep(); UART_Lower_Sleep(); ADC_DelSig_1_Sleep(); VDAC8_1_Sleep(); CyPmSaveClocks(); CyPmHibernate(); CyPmRestoreClocks(); Timer_1_Wakeup(); I2C_Wakeup(); UART_Upper_Wakeup(); UART_Lower_Wakeup(); ADC_DelSig_1_Wakeup(); VDAC8_1_Wakeup(); Any advices ?
Labels
- Labels:
-
PSoC 3
2 Replies
Dec 04, 2012
06:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 04, 2012
06:31 AM
You observing the precautions and methods in these -
http://www.mymcu.ru/content/articles/Cypress/AN66083.pdf
http://www.cypress.com/?docID=37054
Regards, Dana.
Attachments are accessible only for community members.
Anonymous
Not applicable
Dec 04, 2012
10:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 04, 2012
10:27 PM
Dana, Thanks for your help. I have read the app-note carefully and tried to fix the problem, but I haven't. I have posted my sample project which can replicate the problem. After about 5 minutes in Hibernate mode, it sometimes reset and run from the initial. Any more advice will be appreciated.