Anonymous
Not applicable
Dec 07, 2012
03:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2012
03:44 AM
Hello,
I try to realize a synchronous demodulating of a signal modulated in 100khz.
I test the use of PSoc1. The use of " Modulation
Inputs " in a SCC Block seem to allow it. But I do not how see routing this input with
PSoc designer 5.3.
Labels
- Labels:
-
PSoC 1
2 Replies
Anonymous
Not applicable
Dec 07, 2012
05:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2012
05:03 AM
The routing for modulation input of SC BLOCK (generic) user module is not shown in the device editor of PSoC Designer. You need to write into AMD_CR0 or AMD_CR1 register.
For more details about this register, please refer technical reference manual of the selected device.
-Rajiv Badiger
Dec 07, 2012
07:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2012
07:34 AM
In the TRM the section "23. Switched Capacitor PSoC Block" has the
registers you will need. Also AN2014 would be useful -
http://www.cypress.com/?rID=2899
Regards, Dana.