- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
can I use the Cy8C55 Processor Module wich is inkludet in the CY8YKIT-001 witout the dev-Board.
On the Module is a pin called VBAT and there are 2 GND pins.
If its possible how many Volts can i connect there.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is not easy but possible, you can find the circuit diagram of the board. Not sure if it comes with the board or in the CD.
These two thread may help
http://www.cypress.com/?app=forum&id=2233&rID=70462
or
http://www.cypress.com/?app=forum&id=2233&rID=69916
happy prototyping 🙂
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, you can do that, but you need to supply all the needed signals. Out of the blue you need:
- on J1, the reset signal, the supply voltages and maybe the JTAG / SWD signals
- on J2-J4, you need to supply the supply voltages (Vdda and Vddio)
If you want to manipulate the module, you can connect the supply voltages together with some wires, then you would need only the connection on J1.
As for Vbat: you would need the internal boost converter for this, but this has been disabled on the PSoC5 devices due to some problems.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wouldn't it be easier to just design a basic CY8C5XXX breakout board?