Anonymous
Not applicable
Dec 07, 2012
12:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2012
12:31 AM
Hi i have question about flagD in slavefifo example.
As document, flagD was using ep6 full flag.
But i so confused this full flag's syntax meaning.
As i know, ep6 is IN.
So if fx2's fifo is empty, why flagD is goto high transition?
Is high(0->1)meaning full? or empty?
Why flagD is goto high?
What is mean that the ep6 full flag go to high?
Labels
1 Reply
Anonymous
Not applicable
Dec 09, 2012
09:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2012
09:26 AM
Hi,
Yes. If you configure FlagD to indicate the status of EP6 FF then FlagD goes high whenever the EP6 gets completley filled with data.
Could you please show the piece of code where you are configuring the FlagD to indicate the status of EP6 FF.
Thanks,
sai krishna.