- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello guys,
I just wanted to build an slavefifo example code
and I have an error
cyu3lpp.a : No such file or directory
Can you help me with this
Thanks in advance
regards
Pruthvi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
this is how the exact error looks
arm-none-eabi-gcc: C:\Programme\Cypress\EZ-USB FX3 SDK\1.0\\firmware\u3p_firmware\lib\fx3_debug\cyu3lpp.a: No such file or directory
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am normally not concerned with USB Controllers but with errors of (in) software (smile)
First thing I would check is if the required path does exist or not. I assume, it does not.
Would be good to find out if the file requested exists in a different directory.
Next stage would be to find out why the software assumes this path and not the correct target.
Whish you a happy (error-free) 2013
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hii,
I actually made a copy of my firmware to a new workspace in the same directory and this error pops up, only for Snycslavefifo example I tried to build USBmanytoone example and works perfectly
strangly I noticed, when I build the slavefifo example in the older workspace it works fine.my older workspace consists of all the firmware examples. may be slavefifo example needs some other functions to run ??
Any suggestions??