- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!!
I got a problem with the SmartSense i´m use Proximity Sensor in the chip cy8c21334B-24PVXI, when i near to the cable in the proximity sensor should ligth a LED but this not happen i do know why :S I´m use too the cy8c21345-24sxi and in this chip work perfectly and I use the SmartSense also so if sombody can helpe i´ll be grateful
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Some trouble-shooting tips-
1. Ensure proximity pin, CMOD pin and feedback resistor pin are selected properly in the wizard
2. Monitor raw counts using bridge control panel software or equivalent tool. Ensure you are getting sufficient count variation.
3. Follow "step by step Tuning guide" section given in the user module datasheet
4. Ensure you are not creating resource conflicts. See section "Eliminate possible resource use conflicts" section in user module datasheet
-Rajiv Badiger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just stumbled over this post http://www.cypress.com/?app=forum&id=1573&rID=73424 that might have to do with your problem.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob, are you on the link you provided in previous post? User is facing problems with the smartsense module. He is using LED to know the status and not mentioned anywhere about UART.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When Capsense is changing the UART-clock it is most likely that it may change the I2C clock as well resulting in the described behaveour. So if taking the given advices in the other thread may help the user out.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bob, I tend to disagree with you on this. I2C HW block uses system clock which cannot be changed by capsense module. The issue here could be related to tuning or HW.
fco18, can you please attach your project?
-Rajiv Badiger
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI:
I solved the problem, i had a mistake in my PCB design , but fortunately i could fix it without making another PCB.
Thanks at all.