Anonymous
Not applicable
Dec 26, 2012
09:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 26, 2012
09:54 AM
Hello All,
If I load the default configuration file provided by Cypress (when I installed the drivers) from the directory C:\Cypress\USB\CY4605-HX2LP\1.0\Software\Config_file\2_port.iic for CY7C65620 into the CY7C65630 part, will it function correctly?
Since CY7C65620 is 2-port hub and when the same config file is loaded into a 4-port hub part, will only 2 ports be enabled?
If a config file has already been loaded into a device using Primer.exe, how can I load different config file into the same device. When I use Blaster.exe to do a Read From EEPROM, I get a message " Cannot Open Device" and I cannot erase the EEPROM also using the blaster application.
Thank you for the support.
1 Reply
Anonymous
Not applicable
Jan 09, 2013
04:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 09, 2013
04:08 AM
Hi,
Yes, Only two ports will be enabled.
The device needs to be bound to "Cypress USB Hub Manufacturing driver", available in C:\ProgramFiles\Cypress\CY4606-HX2LP RDK\Software\Driver,for accessing through Blaster.
Regards
Prajith