- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am usning USB3 connection only. Do I need connect D+ and D- line? If yes what is functionality of these lines in USB3 protocol.
Thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You need D+ and D- lines if you want to operate your device in USB2.0 speeds (High, Full and low speed).
Thanks,
sai krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
And if not? I want only superspeed. Somebody told me that USB agents need it for autonegotiation...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
If you want only superspeed then you can leave D+ and D- open. There should not be any problem with the functionality of device under superspeed but it is not expected to pass USB certifications.
Thanks,
Sai Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I tried to mask the D+/D- pins, to simulate this issue, and did _not_ see the Cypress on the PC.
Please note that in our system configuration the boot is via USB, so the booter should loat the code on the USB3.
Does the booter support USB3 operation?
Thanks,
Avishai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
That is the problem in your case. FX3 bootloader works in USB2.0 mode; not in USB3.0.
So it is not possible to leave out the D+ and D- lines if you are opting for USB boot.
Thanks,
sai krishna.