EZ-USB® FX2™/FX2LP™ Oscillator Is Not Running – KBA90541
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Version: **
Question: What should you check if the oscillator is not running on the FX2™/FX2LP™ board?
Answer:
You should check the pin connections and the oscillator characteristics to ensure they comply with the EZ-USB® FX2LP™ USB Microcontroller High-Speed USB Peripheral Controller datasheet. For example, the RESERVED pin must be connected to GND, as specified in the datasheet Pin Descriptions. Not connecting the RESERVED pin to GND puts the chip in a test mode which can cause the observed behavior.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous