Reading the checksum after security fuse has been blown
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: When programming the M8 parts, after the security bit has been blown, can I read the checksum?
Answer:
No, you can't. Once the security fuse has been blown, reading only shows 0xFFs.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous