QDR Point-to-Point termination
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Is it required to terminate the lines when QDR is driving the bus for a point-to-point link?
Answer:
No, QDR has a feature that can adjust the output impedance to match that of the trace impedance. This can be accomplished by adding a resistor five times that of trace impedance to pin ZQ. ZQ will control the impedance of all outputs when the QDR is driving the bus. This method has a tolerance of ~10%. The output impedance can be adjusted between 35 ohms to 70 ohms.
Labels
- Tags:
- synchronous srams
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous