CY22395 S0 & S1 Signals
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: When creating a *.jed file with CyClockRT, there seems to be no place in the GUI to set S0 and S1. How can these be set in the bitmap?
Answer:
CyberClocks currently only allows for two table entries on PLL1. That means 000, 001, 010, and 011 are all set to the same VCO frequency and 100, 101, 110, and 111 are all set to the same value. If eight table entries are needed, the CY22392 can be used.
- Tags:
- clock generation
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous