External SUSPEND Pin for the FX2
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Is there a way to bring out a SUSPEND pin for the EZ-USB FX2 chip, CY7C68013, to turn off other devices?
Answer:
There is not a dedicated suspend output pin on the EZ-USB FX2 chip. To provide an external suspend signal you will need to configure one of the general purpose I/O pins to assert when the FX2 detects a SUSPEND interrupt.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous