PSoC programmer - Reset Programming mode
Anonymous
Not applicable
Jan 19, 2010
11:09 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 19, 2010
11:09 PM
Answer:
Question: Is there a need to reset or power cycle the PSoC after programming in “Reset Mode” using MiniProg and PSoC Programmer software?
Response: In earlier versions of PSoC Programmer, the user had to reset the system after programming in Reset mode. From PSoC programmer 3.10 and above, the software sends a Reset signal at the end of programming. So there is no need for power cycling or resetting the PSoC after the programming completes.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous