Routing Clocks to External Pins
Anonymous
Not applicable
Mar 20, 2011
12:30 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 20, 2011
12:30 PM
Question: Can I route the 24MHz clock to an external pin in PSoC 1 ?
Answer:
No, 24MHz signal can't be routed to an external due to the driver limitations on the GPIO pins in PSoC 1. Only signals under 12MHz can be routed to an external pin. You can however, use a maximum of Sysclk*2 (48 MHz) as a clock internally.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous