Connecting an Analog Signal on P0[x] to an ADC
Anonymous
Not applicable
Jun 26, 2011
12:03 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jun 26, 2011
12:03 PM
Question: How do I connect a signal from and analog input pin on Port0 to an ADC?
Answer:
An ADC uses an SC Block and hence can only be placed on Row1 or Row2 in the analog blocks. These blocks do not have a direct access to the Analog Column Input muxes that connect to the analog input pins of Port0. To connect the input pins on Port0 to the ADC, place a PGA in the CT block of the corresponding (or adjacent) analog column, set the gain of PGA to 1 (or any desired value), connect the Port0 pin to the input of the PGA and connect the output of the PGA to the input of the ADC.
Labels
- Tags:
- psoca 1
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous