Sleep Wakeup from Pins -- PSoC
Anonymous
Not applicable
Jan 01, 2012
04:18 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 01, 2012
04:18 AM
Question: Is a wakeup in the sleep state possible by an interrupt generated from any pin?
Answer:
Any port pin can be used to wakeup the PSoC by using the GPIO interrupts. Refer the application note, "AN47310 - PSoC® 1 Power Savings Using Sleep Mode" for more details.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous