Using USBIOs as GPIOs in PSoC® 3 and PSoC 5LP
Anonymous
Not applicable
Jan 08, 2016
02:53 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jan 08, 2016
02:53 AM
How to use USBIOs (D+: P15[6] and D-: P15[7]) for GPIO functionality?
USBIOs only support the drive modes ‘Open Drain, Drives Low' and 'Strong Drive'. If your GPIO is any of these drive modes, then you will be able to assign USBIOs (D+: P15[6] and D-: P15[7]) to your GPIO in the PSoC Creator™ cydwr Pins tab. If the drive mode of the GPIO is different from these specified drive modes, the pins P15[6], P15[7] cannot be assigned to the GPIO.
Version: **
Translation - Japanese: PSoC® 3 / PSoC 5LP USBIO を GPIO として使用する - KBA92716 - Community Translated (JA)
Labels
Rate this article: