Inventek Systems releases ISMART User's Manual!

    Inventek Systems releases the ISMART (Inventek Systems Module Arduino Test), User's Manual.

     

    The ISMART IoT platform is a user-friendly Arduino compliant shield suited for all of your wireless application needs.

     

    The ISMART platform enables customers to quickly launch IoT product based development on any preferred host MCU of choice.

    The robust user friendly Inventek AT command set FW, IWIN (Inventek Wireless Interoperability Network), makes it easy to take any Host microcontroller and communicate with any Inventek eS-WiFi (embedded Serial Wi-Fi), module, thus allowing customers to quickly get a Wi-Fi connected application up and running.

    All of Inventek's eS-WiFi modules are based on Broadcom’s Wi-Fi, BT/BLE and NFC combo radios.

     

    The ISMART User's Manual provides a detailed hardware requirements overview and all associated board connections.

     

    Shield_Top3.jpg

                                                                  OR

     

                                                  ISM43362-M3G-L44

                     Shield labels Bottom.jpg

    ISMART Hardware Features:

    • Uses the Inventek ISM43341/0 (2.4/5G+BT/BLE+NFC eS-WiFi module), or ISM43362 (2.4G Wi-Fi eS-WiFi module), leveraging Broadcom’s leading edge radio devices.
    • Includes an ST Microcontroller Cortex M3 STM32F204 (ISM43362) or Cortex M4 STM32F405 (ISM43341/0), MCU.
    • Bluetooth 4.0 including BLE support.
    • 2.4GHz (ISM43362) or 2.4/5 GHz (ISM43341/0), chip antenna on module.
    • U.FL external antenna connector option for both modules
    • Configurable using Inventek AT Commands FW (IWIN).
    • Host interface: UART, SPI. 
    • Input Power: 5.0 V
    • Near Field Communication (NFC option), with the ISM43341/0 eS-WiFi modules.
    • Dual Port FTDI for firmware development and testing.
    • SPI Flash for Over The Air (OTA) updates
    • FCC, IC and CE approval on all module options.
    • All eS-WiFi module options also support a standard L44 form factor to enable customers to migrate between module options once in mass production without requiring any board layout changes.

    IS-Logo.jpg

    2 Republic Road

    Billerica, MA 01862

    978-667-1962 Office

    978-667-1949 Fax