Run BlinkyLED Application in ModusToolbox 1.1 with CY8CKIT-062-4343W Kit - KBA226792
Employee
Mar 19, 2019
11:40 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 19, 2019
11:40 PM
The default BlinkyLED application in ModusToolbox™ version 1.1 doesn’t work with CY8CKIT-062-4343W Kit because the User LED, which is used for the BlinkyLED application, is mapped at P0[3] in ModusToolbox.
The User LED is connected to P13_7 (i.e., P13[7] ) on the CY8CKIT-062-4343W Kit.
Therefore, you must change port assignment from P0[3] to P13[7] with the same configuration in ModusToolbox.
After this modification, you can build the project and run the BlinkyLCD application with CY8CKIT-062-4343W Kit.
Rate this article: