PSoC Creator Not Allowing Pin Initial State as Low in PSoC 4 – KBA223287

Version 2

    Version: **

     

    Translation - Japanese: PSoC CreatorでPSoC 4のピンの初期状態をLow設定できない – KBA223287 - Community Translated (JA)

     

    Question:

    When I change the Initial drive state of the PSoC® 4 output pin to Logic Low, I am getting the “Unhandled Exception” error. Why?

    Answer:

    When the option Output enable is selected, the configuration window will throw an exception when you try to change the Initial drive state. This a known issue in PSoC Creator™ and will be fixed in future release.

     

    Workaround:

    Write Logic Low on the pin in firmware. Pin will not drive Logic High until the output enable signal is Logic High.