Question: I am getting the following error "Socket 1 ... Programming Error" when I attempt to program the device. I can read it fine but cannot write into it. The file I read looks just like the following:CY22394FFuse map produced by PRO-20X device programmer*QF5632*L00000 0000000000000000000000000000000000000000000000000000000000000000*L00064 1111111111111111111111111111111111111111111111111111111111111111*L00128 1111111111111111111111111111111111111111111111111111111111111111*L00192 1111111111111111111111111111111100000000000000000000000000000000*L00256 0000000000000000000000000000000000000000000000000000000000000000*L00320 0000000000000000000000000000000000000000000000000000000000000000*L00384 0000000000000000000000000000000000000000000000000000000000000000*L00448 0000000000000000000000000000000000000000000000000000000000000000*L00512 1111111111111111111111111111111111111111111111111111111111111111*L00576 1111111111111111111111111111111111111111111111111111111111111111*L00640 1111111111111111111111111111111111111111111111111111111111111111*C2BD4*AC97
The data, shown above, read by the programmer from CY22394 is a signature of one of the following:
- The socket Adapter is not the correct one. Make sure you use CY3672ADP003 socket adapter (marketing part number CY3698).
- Bad contact between device pads and socket pins. Please visually verify good connection of the socket pins to the part pads.
- Bad Device Orientation. Please check the device pin 1 orientation indicated by the symbol in the top right corner of the programmer.
- You did not select CY22394 from the device list. Please make sure to select CY22393 by double clicking on CY22394 from the device list that is shown after starting the software. Leave the settings on default and click start in the CY22394F setting... pop-up window. Device driver is then downloaded into the programmer and prompts you to browse to your JEDEC file location.