Programming Multiple PSoC1s Using ISSP?
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: Can I program multiple PSoC1s using ISSP?
Answer:
No. There is a handshake sequence where the data is verified through communication from the chip back to the programmer. You cannot use the same header to program more than one chip, otherwise the data verification would cause contention on the data line.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous