Push/Pull output pins in the CY7C036 family
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Answer:
Questions:
- Are the INT and BUSY output push/pull signals?
- Are the INT and BUSY output open drain signals that require a pull-up resistor?
- Do I need to connect pull-up resistors to the output pins on the CY7C036/038/057 devices?
Response:
The output pins on the CY7C036/038/057 family of devices are push/pull. There is no need to connect pull-up resistors to these outputs.
Labels
- Tags:
- dual-port srams
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous