Assertion of INT0# pin on FX does not trigger an Interrupt
Anonymous
Not applicable
Dec 19, 2008
12:00 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 19, 2008
12:00 AM
Question: For how long the INT0# pin should be asserted for an interrupt event to be detected?
Answer:
The INT0# pulse needs to be at least 4 CLKOUT cycles long in order for the interrupt to be detected by the 8051 core. Check that this is being satisfied as a minimum requirement.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous