Multiple instances of ADC8 and ADC10 user module

Question: Can I use multiple instances of ADC8 and ADC10 user module in my project?

 

Answer:

The single slope ADCs, ADC8 and ADC10, use a hardware resource, ADCPWM, for timing. There is only one ADCPWM resource is available on the PSoC and other devices that support this user module, so if you place more than one of these ADCs in a design, one or both of the ADCs will exhibit timing problems.

This UM is supported by following device families: CY8C21x23, CY8C21x34, CY8CLED02, CY8CTST110, CY8CTMG110, CY8C21x45, CY8C22x45, CY7C603xx, CYWUSB6953