Binding miniprog3 to the appropriate driver manually
Anonymous
Not applicable
Oct 01, 2010
01:10 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Oct 01, 2010
01:10 PM
How to bind miniprog3 to the appropriate driver manually?
The mprog3.inf file located at the following address is the driver file which need to be binded with miniprog3. This inf file points to sys file which is required for connecting miniprog3 to USB.
C:\Program Files\Infineon\Programmer\3.12\drivers\mprog3
Follow the steps in the attached 'MiniProgUpdateDriver.pdf ' file for the same, it includes the screen shot of each step.
If miniprog3 is coming as unconfigured in device manager, then follow "Miniprog3 unconfigured" KB article at this link.
Labels
Rate this article: