PCB coating in CapSense
Anonymous
Not applicable
Feb 26, 2011
12:19 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Feb 26, 2011
12:19 PM
Question: In CapSense desings, can varnish be used for PCB coating?
Answer:
Conductive varnish should not be used, if the varnish is non-conductive there will be no problems with coating the PCB. However, the coating should be done on the prototype too and then the project be tuned, as it will change the electrical characteristics of the PCB.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous