Neuron Reset Droop
Employee
Dec 21, 2009
04:36 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Dec 21, 2009
04:36 PM
Question: Why is a 10ms droop required on the Neuron reset line?
Answer:
This droop is required because it takes the Neuron device at most 10ms to finish a block write. If at least 10-15ms of droop is not met, then the flash may become corrupted during a power failure.
Labels
Rate this article: