Using FX2/FX2LP can I pull up SDA and SCL line to 5V power supply?
Anonymous
Not applicable
Mar 29, 2011
01:55 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Mar 29, 2011
01:55 PM
Question: I would like to use an FX2/FX2LP with an I2C slave device operating at 5V. Can I pull up SDA and SCL line to 5V power supply?
Answer:
Yes, you can pull-up the SCL and SDA pins to 5V as they are 5V tolerant. Note that the FX2/FX2LP can only act as an I2C master and not a slave device.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous