Attachments are accessible only for community members.
GPIF decoding using the register values
Anonymous
Not applicable
Apr 03, 2011
01:15 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 03, 2011
01:15 AM
Question: Is it possible to regenerate the GPIF waveform without the .gpf file in FX2LP?
Answer:
Yes, it is possible to regenerate the GPIF waveform and figure out what is happening with the gpif by decoding the register values which are discussed in section 10.3.4. For more information you can refer Section 10.3.4 of the attached EZ-USB TRM.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous