Using the RDY5 Feature in GPIF of FX1/FX2/FX2LP
Anonymous
Not applicable
Apr 03, 2011
02:56 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 03, 2011
02:56 PM
Question: What is the RDY5 feature and how do I turn it on for FX2?
Answer:
This will allow you to use the transaction count expiration signal as a ready input to a GPIF waveform. Setting this bit will take the place of the pin RDY5 in the decision point of the waveform. In order to use the RDY5 feature in conjunction with the transaction count, you should set bit 5 in GPIFREADYCFG.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous