Adjusting Amplifier Gain in Hardware
Anonymous
Not applicable
Feb 26, 2011
07:47 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Feb 26, 2011
07:47 AM
Question: Can I adjust the Programmable Gain Amplifier's gain with hardware?
Answer:
No. Resistor taps or capacitor ratios determine the gain on PSoC amplifiers. It can only be configured by programming the appropriate register bits. If the application requires a General Purpose OPAMP then SC Block can be make to worklike a FAUX Opamp. For details on this please refer to Application Note: AN2223.
Labels
- Tags:
- psoca 1
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous