Programming the EEPROM for the TetraHub
Anonymous
Not applicable
May 19, 2011
08:14 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
May 19, 2011
08:14 AM
Question: How do you program the EEPROM for the Tetra Hub? Must it be done separately on a programmer, or can it be programmed over the USB?
Answer:
You need to use a separate EEPROM programmer. Please inquire the vendor where you purchased the EEPROM from for further information on how to program these parts.
Related Documents and Links:
BP Microsystems
Labels
- Tags:
- hi-speed usb hubs
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous