Current Status of the READYx Pins for the CY7C68013
Anonymous
Not applicable
Jun 13, 2011
12:10 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Jun 13, 2011
12:10 AM
Question: Is it possible to read the current pin status of the GPIF ready lines through firmware?
Answer:
As mentioned in section 15.13.15 of the EZ-USB technical reference manual, the current state of the RDY[5:0] pins can be read from the GPIFREADYSTAT register. This register contains the state of the READY[5:0] lines sampled at each rising edge of the GPIF clock.
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous