Termination design on the Sync SRAM NoBL

Question: What is the recommendation for the termination design for the Standard Synchronous/ NoBL SRAMs ?

 

Answer:

 For the Standard Synchronous/ NoBL SRAMs it is typically recommended to use series termination or pull-up (pull-down) termination on the clocks and the data signals, and optionally on the address and the control signals depending on how the signal integrity looks. For more details see the Types of Termination section in the attached ?High Speed Memory Design Techniques-AN4010? application note. In any termination option used, the value of the termination resistor used should match the characteristic impedance to prevent reflections.