PSoC 1 Bootloader project: Application starting address
Anonymous
Not applicable
Oct 17, 2011
12:42 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Oct 17, 2011
12:42 PM
Question: Where should I place my application start address when using a bootloader in a PSoC 1 project?
Answer: The application start address comes after the last row of the bootloader. Make sure to leave enough flash memory for the application code. Is often beneficial to place one block of flash between the bootloader and the application. See the bootloader data sheet for more information.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous