Interfacing Image Sensor with EZ-USB® FX3™ - KBA87001
Anonymous
Not applicable
Apr 12, 2013
07:02 AM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Apr 12, 2013
07:02 AM
Version: **
Question: How do I interface the USB FX3 device to an image sensor?
Answer:
The USB FX3 device interfaces directly with any image sensor using an 8- or 12-bit parallel bus. Other image sensors using HiSPI, LVDS, or MIPI interfaces can be connected to FX3 through a CPLD or FPGA. Since FX3 does not contain any Image Sensor Pipeline (ISP) logic, you can use an image sensor with built-in ISP, an FPGA with ISP logic, or running software ISP on a host PC.
Labels
Rate this article:
Contributors
-
This widget could not be displayed.Anonymous